5
GENERAL PUMP INFORMATION
This pump is designed to sprinkle lawns and small gardens from lakes, ponds, or rivers, empty or
ll stock tanks, remove standing water from ooded areas, transfer water or boost water pressure.
Flammable liquids such as gasoline, chemicals, or corrosive liquids should never be used with this
pump.
The pump is NOT designed to operate underwater.
SETUP
1. Before installing pump (A), have the electrical circuit checked by an electrician to ensure proper
grounding.
BE CERTAIN the pump (A) power source is disconnected before installing or servicing this unit.
Be sure the water source and piping are clear of sand, dirt, and scale. Debris will clog pump (A)
and void warranty.
Failure to protect pump (A) and piping from freezing could cause severe damage and will void the
warranty.
Do not run pump (A) dry.
INSTALLATION INSTRUCTIONS
PUMPING FROM LAKES, PONDS, OR SMALL
STREAMS
1. Set pump (A) as close as possible to the water
source, keeping the vertical distance from
the water to pump as short as possible and
no more than 20 ft. Place pump (A) on level
support. Protect against ooding and excessive
moisture.
Long lengths of pipe or hose and use of many
ttings will reduce the amount of water this unit
will pump. Use the smallest number of ttings
and shortest possible length of pipe or hose.
A
Water source
Outlet
Inlet
Maximum
20 ft.
vertical
distance
1
To Next Page
Loading...
Need help?
General
