V2 Easy4 User Manual

ENGLISH
30
OPERATION WITH REMOTE CONTROL
Operation of the remote control units depends on
the configuration of function 1.
START/STOP logic: only the memorised button
activates an OPEN or CLOSE command.
UP/DOWN logic: each button on the remote
control is associated with a function.
Simply memorise any button on the remote control
to activate operation of the other 3 buttons.
* The courtesy light can be controlled by button 4 on the remote control.
The operational logic is bistable: if the courtesy light is off, it comes on, and vice versa. In any case, the light
switches off after 10 minutes.
 PLEASE NOTE: It is not possible to switch off the courtesy light while the door is moving.
UP
DOWN
STOP
COURTESY LIGHT*
MEMORISING REMOTE CONTROL UNITS
1. Press the MENU button briefly
2. The control unit activates the radio acquisition phase: the LEDs come on rapidly, moving from left to right
3. Within 5 seconds, transmit using the button on the remote control it is desired to memorise
4. All the LEDs come on for 2 s to indicate the remote control unit has been memorised
5. The control unit switches to radio acquisition mode for 5 s: the LEDs come on rapidly, moving
from left to right
6. Transmit using another remote control unit to be memorised, or wait for the LEDs to turn off
 PLEASE NOTE: when the memory is full, and hence it is not possible to memorise other remote control
units, any attempt to activate radio acquisition will result in the control unit responding by flashing all the
LEDs for 2 s.

V2 Easy4 Specifications

General

Brand	V2
Model	Easy4
Category	Control Unit
Language	English