Start-up
Operating and installation instructions 0020248967_00
33
6
6 Start-up
6.1 Adaptive run
An adaptive run (Valve adapt) must be
carried out after the installation.
> If Valve adapt is shown in the display,
start the adaptive run by pressing the
setting wheel.
– During the adaptive run, Valve adapt
is shown on the display.
i
Note
No other operation is possible dur-
ing the adaptive run. After a suc-
cessful adaptive run, the display
switches back to the normal display.
> If the adaptive run was initiated before
the installation or if a fault message (F1,
F2, F3) is displayed, press the setting
wheel.
– The motor moves back to the Valve
install position.
To Next Page
Loading...
Need help?
General
