8
2.2 Product Components
The EzSensor HD device installer should check the following items listed in the table below
before Productinstallation. If the serial numbers of the individual parts do not match, do not
install the Product. Contact your local distributor or agent for support.
This Product should be connected with a device or product which is complied with IEC 60601-1.
<Table 2. EzSensor HD Product components>
No Components Remarks
1. Sensor Module* 2.7m USB cable is all in one
2 Wrap* (Hygienic Sleeves)
3. Holder for Sensor
4 Silicon cover*
5. S/W Installation CD(or USB) EasyDent(or EzDent-i)
6. Driver Installation CD USB Device Driver
7. EzSensor HD Manual Document
* Patient applied part (Inside Patient environment)
Sensor Module:
Consists of a special CMOS sensor specifically designed for use in radiography and
enclosed in a hermetically sealed ergonomic capsule. The sensitive surface of the
sensor is covered with a thin layer of scintillating phosphorous, through which X-ray
radiation is converted into light and then into an electric charge.
To Next Page
Loading...
Need help?
General
