4
Electrical safety
The covers of the Product may be removed only by qualified and authorized technical
personnel.
This Product can only be used in rooms or areas that comply with all laws and regulations
applicable to electrical safety on medical premises, such as IEC standards for the use of an
additional ground terminal for equipotential connections. This Product must always be
disconnected from the power supply before cleaning or disinfecting.
This Product should be connected with a PC which is complied with IEC or ISO safety
standards. Please dip the sensor in either of the cleaning solutions listed above 6.3 Care and
Cleaning for less than 60 seconds. After immersing the sensor in disinfectanct, use a dry cloth
to wipe the sensor, Use of other disinfectant may cause discoloration, but will not cause
dysfunction of the sensor.
Explosion safety
This Product is not recommended for use in the presence of flammable gases or vapours.
Some disinfectants evaporate and form explosive or flammable mixtures. If disinfectants of this
kind are used, it is important to let the vapours disperse before using the Product again.
For the improvement of Product performance, supplementation, and follow-up of information,
the contents of this manual are subject to change without prior notice.
X-ray protection
The rules of dental radiography apply to digital X-ray systems. Please continue to use
protection for your patients. As a clinician, clear the immediate area when exposing the sensor.
To Next Page
Loading...
Need help?
General
