Vax ACTION 602 U86-AN-BE User Manual

Press the dirt container
release button, pull to remove.
Emptying the dirt container
Cleaning the HEPA pre-motor lter
Hold dirt container
over a bin.
Press the dirt release clip,
allowing dirt/debris to fall out.
Turn the dirt container
release button, pull
to remove.
24hr
Leave to dry for
24 hours or until
fully dry before
placing back in the
vacuum cleaner.
Turn the HEPA
pre-motor lter
anti-clockwise,
pull to remove.
Tap HEPA pre-motor
lter over a bin to remove
any dirt/debris.
Rinse under water
(max 40°C).
Line up HEPA
pre-motor lter tabs
in dirt container lid,
turn clockwise until it
clicks into place.
Taking care of your machine
Filters require cleaning at least every 3-6 months (depending on the level of use).
Don’t use your vacuum cleaner without all the lters in place.
IMPORTANT: The motor is equipped with a thermal cut-out. If for any reason the machine should overheat, the
thermostat will automatically turn the machine o. Switch o and unplug the vacuum cleaner. Check the machine
for blockages and clean the lters. Wash the lters with warm water (40°C max) and leave for 24 hours or until
fully dry before replacing into the machine.
TIP
Don’t over ll the dirt
container to avoid blocking
the air ow through the
vacuum cleaner and replace
lters every 6-9 months.

Vax ACTION 602 U86-AN-BE Specifications

General

Brand	Vax
Model	ACTION 602 U86-AN-BE
Category	Vacuum Cleaner
Language	English