Removing dirt/debris from TurboTool (some models only)
Removing debris from the brushbar
Using a pair of
scissors cut any hair
or debris free from
around the brushes.
Line up the tabs on front
of the housing and re-t.
Slide locking ring into
groove to secure.
Slide the locking ring
to remove.
Using a pair of scissors
remove any threads or
hair caught around the
brush bar.
Tabs
Lift and separate
the housing.
IMPORTANT: Unplug and switch o vacuum cleaner before performing maintenance or troubleshooting checks.
Let’s talk technical
TIP
To test for a blockage in the hose,
drop a small ball of paper through
the hose. The paper will drop
through if the hose is clear.
To Next Page
Loading...
Need help?
General
