Vax Agility V-123 User Manual

www.vax.co.uk
8
cleaning carpet / cleaning upholstery
Let go of trigger and push cleaner over same area to pick
up dirty solution without putting down more solution.
Continue using dry strokes until you see only a little
solution coming up through the nozzle (front of cleaner).
Do not make the carpet too wet! Use no more than two
sets of forward and backward strokes while releasing
solution. Always follow with dry strokes - the more the
better.
Listen carefully! When the motor sound changes (rises in
pitch), the recovery tank needs to be emptied.
NOTE: When water has reached the full line in the
recovery tank, the cleaner will NOT pick up any more
dirty solution.
Allow carpet to dry. Avoid walking on the carpet until it is
dry. Increased air circulation (open doors, turn on fans, etc.)
will help carpet dry thoroughly.
Vacuum thoroughly after carpet has dried. This will reduce
any shading left by the deep cleaner’s brushes.
5. Cleaning Upholstery
Check cleaning instructions on fabric. This indicates
whether it is alright to use your deep cleaner to clean the
upholstery.
Do not use the deep cleaner on upholstery marked ‘Dry
Clean Only’. If you are unsure, please refer to the
manufacturer’s instructions.
Vacuum upholstery thoroughly with your vacuum cleaner’s
attachments.
Test solution for colourfastness on a hidden area of
upholstery. Wet a white cloth or paper towel with some
solution. Gently rub onto a hidden area of upholstery. Wait
ten minutes. Blot with white cloth or paper towel and
check for colour transfer.
Pretreat spots, stains and high traffic areas with Vax stain
treatment spray. Spray spot or area, then proceed with the
next cleaning steps.
For stubborn spots or stains, refer to the stain guide
included with your cleaner.
Fill solution tank with warm tap water (Max 50°C) and
correct amount of Vax cleaning solution (Fig.5/1).
NOTE: Use only Vax brand solutions in your deep
cleaner. Other brands may damage the deep cleaner.
A
ttach hose and t
ool as described in section 3.
Place handle in full upright position. Turn cleaner ON.
Squeeze and hold trigger (A) to release cleaning solution.
Gen
tly pr
ess t
ool in
to fabric and slowly pull the tool over
the fabric (Fig.5/2).
Fig.4/2
A
B
Fig.5/1
Vax V-123 User Guide.qxd 10/8/07 15:43 Page 8

Vax Agility V-123 Specifications

General

Brand	Vax
Model	Agility V-123
Category	Vacuum Cleaner
Language	English