6vax.co.uk
Looking after your machine - Filters
Cleaning the post-motor lter
Cleaning the HEPA pre-motor lter
WARNING: Do not wash the post-motor lter.
IMPORTANT: The motor is equipped with a thermal cut-out. If for any reason the unit should overheat, the thermostat
will automatically turn the unit o. Should this occur, unplug the vacuum cleaner from the electrical socket and turn o
the switch. Remove and empty the dirt container. Check the hose for blockages. Clean the lters. Allow the unit to cool
for approximately one hour (if you have cleaned the lters you will need to wait twenty four hours for the lters to dry
before putting them back in the machine). To re-start the machine, plug it into an electrical socket and switch it back on.
To Next Page
Loading...
Need help?
General
