• The plug may not be fully pushed into the electrical socket.
• Check the fuse in the plug if this needs replacing, as always
replace with a 13amp fuse.
• Make sure the clean water tank is tted securely.
• The clean water tank valve may be stuck. Go to ‘Operating your carpet washer’.
• Check the power brushes for blockages and clear.
• Check the belt. Go to ‘Replacing the belt or brushbars’.
• The oat in the dirty water tank may have been activated. Empty the dirty
water tank, wait for the oat to settle before re-starting your carpet washer.
• Check the dual power brushes for blockages and clear.
• The dirty water tank may not be tted correctly, also make sure the lid
is pushed down securely.
• Check the nozzle for blockages and clear.
SolutionProblem
Warning: Always switch o and unplug the carpet washer from the electrical outlet before assembling, lling and
emptying the clean water tank, emptying the dirt water tank, or before connecting/disconnecting the attachments.
Important: Carpets should be dry vacuumed thoroughly before washing.
Caution: The carpet washer is a very powerful unit. Before plugging the cord into the electrical outlet, make sure all
controls on the unit are turned o. Hold the carpet washer rmly when starting and in use.
Important: The motor is equipped with a thermal cut-out. If for any reason the unit should overheat, the thermostat
will automatically turn the unit o. Should this occur, unplug the carpet washer from the electrical outlet and turn o
the switch. Check the hose for blockages. Clean the lters. Allow the unit to cool for approximately one hour.
To re-start the machine, plug it into an electrical outlet and switch it back on.
What to do if it goes wrong
Why won’t my carpet
washer turn on?
Why won’t the solution/
clean water dispense?
Why won’t my carpet
washer pick up?
Why won’t the
brushes spin?
To Next Page
Loading...
Need help?
General
