Vax ECR2V1P User Manual

Using your machine
TIP
Carpets should be dry vacuumed
thoroughly before washing.
Operating your carpet washer
Remove the clean water tank. Unscrew the clean water
tank cap from the top of
the clean water tank.
Pour required dose of carpet
cleaning solution (approx.
40ml per 1.0L of water) into
clean water tank. NOTE:
Measuring jug is not included.
40C
Max
Tighten cap before
returning tank to unit.
Unwrap power cord
and plug unit in.
Mix solution with warm
water (40°C Max). Fill
the clean water tank with
solution mix.
Turn the machine on.
Recline the machine. Press trigger to
release solution.
For best results apply
solution on the forward
stroke and release the
trigger to recover solution
on the backward stroke.
Your dirty water tank is tted with a oat. When the dirty water tank is full or the oorhead is not in contact with the
carpet the oat will shut o the suction at the oor nozzle. You will be able to hear if this has happened as the motor
noise on the unit will increase. Once the oat is activated, empty the dirty water tank if full. If the dirty water tank is not
full then turn o your machine at the power switch and wait for the oat to settle.
NOTE: If the solution/clean
water doesn’t dispense, the
clean water tank valve may
be stuck. Hold the clean
water tank over the sink and
press the valve underneath
to release.

Vax ECR2V1P Specifications

General

Brand	Vax
Model	ECR2V1P
Category	Vacuum Cleaner
Language	English