1. Turn off the vacuum cleaner and unplug it from
the mains. Remove the hose. Unclip the retainer
clips on either side of the vacuum cleaner and lift
off to gain access to the dust bag compartment
(Fig.7/1).
Fig.7/1
2. Lift out the full dust bag (Fig.7/2).
Fig.7/2
3. Dispose of the full dust bag and insert a new dust
bag back into the vacuum cleaner aligning the
front of the dust bag with the inlet slots (Fig.7/3).
Fig.7/3
Pre-motor Filter
1. Turn off the vacuum cleaner and unplug it from
the mains. Unclip the retainer clips on either side
of the vacuum cleaner and lift off to gain access
to the dust bag compartment (Fig.7/4).
6. Accessories
IMPORTANT: Always remove the power plug from
the wall outlet before assembling or before removing
accessories.
1. The accessories can be attached directly to the
handle by removing the telescopic tubes and
pushing in the desired accessory (Fig.6/1).
Fig.6/1
2. The accessories can also be attached to the
telescopic extension tube for extra reach. Remove
the combination floor tool and push on the desired
accessory (Fig.6/2).
Fig.6/2
Crevice Tool: For crevices, corners, cracks etc.
Dusting Brush: For delicate surfaces.
Upholstery Tool: For carpet, upholstery, stairs etc.
7. Dust Bag & Filters:
Removal & Replacement
IMPORTANT: Always unplug the vacuum cleaner
from the electrical outlet before removing the
dust bag.
IMPORTANT: DO NOT use the vacuum cleaner
without ALL of the filters in place.
6
Accessories/Dust Bag & Filters: Removal & Replacement
To Next Page
Loading...
Need help?
General
