10
USING YOUR MACHINE
Operation
Plug into the mains and
press the On/Off pedal to
switch on.
Press the handle release
pedal and pull the handle
backwards to recline
the machine.
Choose the cleaning mode by turning the dial.
1. Quick Clean Mode:
Best for a quick, surface clean - carpets dry in less
than an hour.
2. Deep Clean Mode:
Best overall results for a thorough, deep clean.
Clip the cord into the
cord hook so that the
cord does not get pulled,
caught or tangled under
the machine.
Squeeze the trigger to
release the solution and
water mix.
IMPORTANT: Carpets should be dry vacuumed thoroughly before washing. For heavily soiled areas, it may be necessary to
repeat the cleaning process. Make criss-crossing strokes across the original pattern and overlap with each pass. Do not over
saturate the carpet. Always finish with dry strokes (trigger released) and continue using dry strokes (trigger released) until
little water is visibly passing through the tool/nozzle.
For best results apply
water/solution on the
forward stroke and
release the trigger on the
backward stroke to pick
up water/solution. For a
dryer finish, follow with an
additional dry stoke with
no trigger pressed.
CAUTION: The brushbars constantly spin when switched on and the machine is reclined. Never use on one spot for an
extended period of time as the brushbars may damage the floor surface.
1 2
To Next Page
Loading...
Need help?
General
