7
8
E
mptying the dirty
w
ater tank
Return dirty water tank to the base
of the cleaner by tipping the nozzle
down into the basin and dropping it
into place.
Lift the front of the cleaner base off
the carpeting with one hand. Line
up the black tabs with the grooves
of the front nozzle. Lift the front
nozzle upwards towards the
cleaner and press under the latch
until it locks into place.
1
2 3
Belt or brush removal
and replacement
Remove dirty water tank and front
nozzle (see page 20) put them to
one side.
Use a Phillips screwdriver to
remove two (2) screws.
Remove the belt cover. Remove the
broken belt.
Phillips screwdriver required
22
23
V-027M User Guide 7/9/06 15:00 Page 11
To Next Page
Loading...
Need help?
General
