1
5 6
Pre-treating your carpets with
the pre-treatment wand and
solution
Remove solution tank cap. CAUTION: Do not overfill. You should leave
1-2 cm of air space.
Fill the tank with pre-treatment solution.
Replace the solution tank cap.
Return the solution tank to the
cleaner making sure the solution
tube lines up with the groove in the
back of the solution tank. Firmly
press the solution tube into the plug
opening of the solution tank.
4
9
7
CAUTION: Maximum water
temperature 40°C.
Remove the clean water tank cap
and put in a safe place. Slowly fill the
clean water tank with warm tap water
(max 40°C) and replace the cap.
Return clean water tank by lining
up the grooves of the clean water
tank with the support posts on the
inside of the handle. Rock clean
water tank inward until it locks into
place.
8
9
Attach the pre-treatment wand to
the pre-treatment water supply port
at the back of the machine. Press
firmly until it locks into place.
N.B Once the pre-treatment wand
is attached it can remain in place
between pre-treatments
Pre-treating your carpets with the
pre-treatment wand and solution
V-027M User Guide 7/9/06 15:00 Page 4
To Next Page
Loading...
Need help?
General
