Caution: Always switch o and unplug the carpet washer from the electrical outlet before assembling, lling and emptying
the clean water tank, emptying the dirt water tank, or before connecting/disconnecting the attachments.
Caution: The carpet washer is a very powerful unit. Before plugging the cord into the electrical outlet, make sure all controls
on the unit are turned o. Hold the carpet washer rmly when starting and in use.
Important: Carpets should be dry vacuumed thoroughly before washing.
• The plug may not be fully pushed into the electrical socket.
• Check the fuse in the plug if this needs replacing, always
replace with a 13amp fuse.
• Make sure the clean water tank is tted securely.
• The clean water tank valve may be stuck, hold the clean water
tank over the sink and press the valve underneath to release.
• Check the power brushes for blockages and clear.
• Check the belt. Go to ‘Replacing the belt or brushbars’.
• The oat in the dirty water tank may have been activated.
Empty the dirty water tank wait for the oat to settle before
re-starting your carpet washer.
• Check the dual spin power brushes for blockages and clear.
• The dirty water tank may not be tted correctly, also make
sure the lid is pushed down securely.
• Check the nozzle for blockages and clear.
• The hose connector door may be open push to rmly shut
(some models only).
SolutionProblem
Why won’t my carpet
washer turn on?
Why won’t the solution/
clean water dispense?
Why won’t my carpet
washer pick up?
Why won’t the
brushes spin?
What to do if it goes wrong
To Next Page
Loading...
Need help?
General
