52
ENGLISH
4.5 MAKING
CAPPUCCINO
To obtain the typical cappuccino foam, immerse
the nozzle all the way into a container 1/3 full of
milk (preferably cone-shaped). Turn on the
steam. Before the milk starts to boil, pull the
nozzle slightly up and lightly move it vertically
across the surface of the milk. When you have
)LJ
CAUTION
RISK OF BURNS OR SCALDING
To use the steam function, pull or push the rel-
evant lever, as shown in the figure.
By pulling it completely the lever will hold a
position of maximum delivery; by pushing it, the
lever will automatically give way.
The two steam nozzles are articulated to guar-
antee their easy use.
4.4 USING STEAM
(Manual steam
wand)
)LJ
While using the steam nozzle, you must pay
attention to not place your hands beneath it
or touch just after it has been used.
NOTE: Before using the steam wand, always
bleed out any condensation for at least
2 seconds or according to the manufac-
turer’s instructions.
4.6 HOT WATER
SELECTION
CAUTION
RISK OF BURNS OR SCALDING
While using the hot water nozzle, pay care-
ful attention not to place your hands beneath
it or touch it just after it has been used.
This nozzle delivers hot water to make tea or
herb teas.
Place a suitable container under the hot water
nozzle. Press the hot water select button once;
the light
will switch on.
The hot water wand will deliver water for the
amount of time equivalent to the set value (see
PROGRAMMING section and the DOSE
PROGRAMMING section) or press the button
again to stop pouring.
NOTE: Hot water can be delivered at the same
time as coffee.
4) Clean the edge of the filter of coffee resi-
dues and insert the filter holder into the
dispensing unit.
5) Position the cup/s under the spout/s.
6) Press the relative
dispensing but-
ton for 1 cup or 2 cups of coffee.
7) The pump activates and starts the dispens-
ing.
8) On reaching the set quantity, the pump
stops and the dispensing automatically
stops.
NOTE: At the end of each coffee dispensing, for
the cleaning of the group, deliver water
for 4-5 seconds.
)LJ
)LJ
completed the procedure, clean the nozzle
carefully with a soft cloth.