23
EN Appendix
8. Technical specifications
MultiPlus
12/3000/120-50 120V 24/3000/70-50 120V
PowerControl / PowerAssist
Input voltage range: 95-140VAC; Input frequency: 45 – 65Hz; Power factor: 1
Maximum feed through current (A)
50
Minimum AC supply current capacity
for PowerAssist (A)
5,3
Input voltage range (V DC) 9,5 – 17 19 – 33
Output voltage: 120 VAC ± 2% Frequency: 60 Hz ± 0,1%
Cont. output power at 25°C / 77°F (VA)
(3)
Cont. output power at 25°C / 77°F (W)
Cont. output power at 40°C / 104°F (W)
Cont. output power at 65°C / 150°F (W) 1700 3000
Zero-load power in AES mode (W) 15 15
Zero-load power in Search mode (W) 8 10
Input voltage range: 95-140VAC Input frequency: 45 – 65Hz
Power factor: 1
Charge voltage 'absorption' (V DC)
Charge voltage 'float' (V DC)
Storage mode (V DC) 13,2 26,4
Charge current house battery (A) (4)
Charge current starter battery (A)
Battery temperature sensor
Auxiliary output Max. 32A Switches off when no external AC source available
Programmable relay (5) Yes, 3x
Protection (2) a - g
VE.Bus communication port
For parallel and three phase operation, remote monitoring and system integration
General purpose comm. port
Common Characteristics
Operating temp.: -40 to +65°C/ -40 - 150°F (fan assisted cooling)
Humidity (non condensing) : max 95%
Common Characteristics Material & Colour: aluminium (blue RAL 5012) Protection category: IP 21
M8 bolts (2 plus and 2 minus connections)
Screw terminals 13mm² (6 AWG)
Dimensions (hxwxd in mm) 362 x 258 x 218
STANDARDS
EN 60335-1, EN 60335-2-29
Emission / Immunity EN 55014-1, EN 55014-2, EN 61000-3-3
1) Can be adjusted to 50Hz;
2) Protection
a. Output short circuit
b. Overload
c. Battery voltage too high
d. Battery voltage too low
e. Temperature too high
f. 120VAC on inverter output
g. Input voltage ripple too high
3) Non linear load, crest factor 3:1
4) At 25°C ambient
5) Programmable relay which can be set for general alarm, DC undervoltage or genset start/stop function