MAINTENANCE
SPA DRAINING
Every 90 days, depending upon water condition, you may need to
renew the spa water. To drain your spa, power must be disconnected
at the circuit breaker. Locate the drain faucet inside the spa cabinet
(for Viking IP, 2P & 3 models) or on the corner near the bottom of the
side panel next to the equipment (for all other models). 1. Twist cap off
and attach a garden hose to the opening. 2. Turn the outside body
counter clockwise until it stops. 3. Pull on the drain that the hose is
connected to until you hear a pop. 4. Drain the spa. 5. Reverse this
procedure to shut the water off. Note: the drain will not remove all of
the water in the spa. You may have to remove a small amount of
water by hand.
DRAIN LOCATIONS
Water Gate Valve
Drain for Viking IP, 2P
& Viking 3 Models
Drain for all
other Models
Operation instructions are virtually the same for all of our models.
16
To Next Page
Loading...
Need help?
General
