Introduction 9
© 2013 Vision Engraving & Routing Systems
Press any Emergency Stop switch to stop the machine immediately.
Be familiar with the location of all emergency stop switches. In the case of an emergency you can
push the nearest one.
Make sure workpiece is properly fastened to table before starting job.
Turn on vacuum table or make sure clamps and other fixtures are tightly fastened. If workpiece moves
during operation you can damage the machine, the workpiece, and serious personal injury may
occur to the operator.
Only use the machine and its attachments for the applications they were designed for. Forcing the
machine or its attachments to do work it was not intended to do may cause permanent damage to the
machine and serious injury may occur to the operator. If there are any questions about the abilities
of your machine, please call the Vision Engraving Systems technical support team at 602-439-0600.
Do not force the machine to work at excessive speeds. The machine will work safely under normal
permissible speeds which are material and application dependent. Using excessive speeds may
damage tooling, material, the machine, and may cause serious personal injury.
Avoid powering on the machine when servicing the machine.
Avoid powering on the machine when installing or replacing parts and/or accessories.
Turn power to the machine OFF when not in use.
Perform required maintenance at the recommended intervals.
Use the general maintenance guidelines to properly maintain your machine.
A disciplined approach to preventative maintenance can extend the useful life of any Router/
Engraver, improve cut quality, and reduce repair costs. Keep records of what and when you perform
maintenance duties.
To Next Page
Loading...
Need help?
General
