Vision CS-1900P Product Manual

2 3
1
Watts
The most consistent standards for measuring watts are
“Program Power” and “RMS” because these measure average
sustained levels.
Where loudspeakers have integrated amplifiers, then load
(resistance, measured in ohms) is known so the wattage rating
is fixed.
2 Connectivity
Master Loudspeaker
Power Input
RS-232
9-pin d-sub
IR Receiver
Switch
Line-level
Input 2-phono
and Minijack
summed
Mini USB
for BT Setup
SW2 Button
For BT setup
Daisy-chain OUT
3.5mm minijack
Daisy-chain IN
3.5mm minijack
Speaker Output
3
Speaker Cable
Speaker cable is included to connect master to slave. You
can use other speaker cable; it must be unshielded with a
gauge of no less than 0.75mm. WARRANTY VOID IF YOU USE
UNSUITABLE SHIELDED CABLE E.G. PHONO OR MINIJACK
CABLE.
4 IR Receiver Switch
FRONT - IR receiver on front active. Remote control can be
used normally
REAR –IR receiver on rear active. Front IR receiver disabled.
Suitable for control system integration.
5 Daisy-Chain
Connect multiple sets together in larger rooms – no limit to
number of sets. The first set in chain is “master set” which
switches inputs and adjusts volume.
Do not connect a laptop or phone directly to the daisy-chain
input.
6 Bluetooth Auto-Switching
Use BT PRIORITY on remote control to enable auto-switching
from line-level input to Bluetooth input when a Bluetooth
device is paired.
With BT PRIORITY on, When a BT device is unpaired the
speakers will switch back to line-level input.
EN
PRODUCT MANUAL CS-1900P
7
Auto Standby
The loudspeakers go into standby after 10 minutes of inactivity.
• Bluetooth device NOT PAIRED when it goes into standby:
• wake up when you pair a device or play audio though the
line-level input.
• Bluetooth device PAIRED when it goes into standby:
• if BT input was selected: only Bluetooth source will wake
them up.
• If line-level input was selected: only line-level input will
wake them up.
8 Status Indicators
BLUE – Bluetooth input
Flashing slowly: Bluetooth is in pairing mode
On: Device paired
YELLOW – Line-level input
On: cable input selected
RED –Standby
Flashing slowly: mute activated
Flashing quickly: IR from remote control being received
On: in standby
9
Remote Control
1
2
3
4
5
6
7
8
9
10
1. POWER On / Off
2. INPUT SELECT Bluetooth / Line-level (cabled) input
3. RESET tone factory reset
4. BLUETOOTH PRIORITY auto-switches when BT device
paired
5. AUTO STANDBY activate or deactivate
6. MUTE
7. TONE treble and bass
8. VOLUME
9. BLUETOOTH activate or deactivate
10. DAISY-CHAIN MODE
a. MASTER Use when
i. Daisy-chain not in use
ii. Daisy-chain in use, this is “master” set, managing
inputs and adjusting volume
b. SLAVE Use when this is a slave set in a daisy-chain.

Vision CS-1900P Specifications

General

Brand	Vision
Model	CS-1900P
Category	Speakers
Language	English