English - ii
IMPORTANT SAFETY INSTRUCTIONS
Your Display is designed and manufactured to operate within dened
design limits. Misuse may result in electric shock or re. To prevent
your Display from being damaged, the following instructions should
be observed for the installation, use, and maintenance of your Display.
Read the following safety instructions before operating your Display.
Keep these instructions in a safe place for future reference.
• To reduce the risk of electric shock or component damage, switch o the
power before connecting other components to your Display.
• Read these instructions.
• Keep these instructions.
• Heed all warnings.
• Follow all instructions.
• Do not use this apparatus near water.
• Clean only with dry cloth.
• Do not block any ventilation openings. Install in accordance with the
manufacturer’s instructions.
• Do not install near any heat sources such as radiators, heat registers,
stoves, or other apparatus (including ampliers) that produce heat.
• Do not defeat the safety purpose of the polarized or grounding-type
plug. A polarized plug has two blades with one wider than the other.
A grounding type plug has two blades and a third grounding prong.
The wide blade or the third prong are provided for your safety. If the
provided plug does not t into your outlet, consult an electrician for
replacement of the obsolete outlet.
• Protect the power cord from being walked on or pinched particularly
at plugs, convenience receptacles, and the point where they exit from
the apparatus.
• Only use attachments/accessories specied by the manufacturer.
• Use only with the cart, stand, tripod, bracket, or table specied by the
manufacturer, or sold with the apparatus. When a cart is used,
use caution when moving the cart/apparatus combination to
avoid injury from tip-over.
• Unplug this apparatus during lightning storms or when unused
for long periods of time.
• Refer all servicing to qualied service personnel. Servicing is required
Safety Information
when the apparatus has been damaged in any way, such as power-
supply cord or plug is damaged, liquid has been spilled or objects have
fallen into the apparatus, the apparatus has been exposed to rain or
moisture, does not operate normally, or has been dropped.
• Unplug the power cord before cleaning your Display.
• When moving your Display from an area of low temperature to an
area of high temperature, condensation may form in the housing. Wait
before turning on your Display to avoid causing re, electric shock, or
component damage.
• A distance of at least three feet should be maintained between your
Display and any heat source, such as a radiator, heater, oven, amplier
etc. Do not install your Display close to smoke. Operating your Display
close to smoke or moisture may cause re or electric shock.
• Slots and openings in the back and bottom of the cabinet are provided
for ventilation. To ensure reliable operation of your Display and to
protect it from overheating, be sure these openings are not blocked
or covered. Do not place your Display in a bookcase or cabinet unless
proper ventilation is provided.
• Never push any object into the slots and openings on your Display
cabinet. Do not place any objects on the top of your Display. Doing
so could short circuit parts causing a re or electric shock. Never spill
liquids on your Display.
• Your Display should be operated only from the type of power source
indicated on the label. If you are not sure of the type of power supplied
to your home, consult your dealer or local power company.
• Do not apply pressure or throw objects at your Display. This may
compromise the integrity of the Display. The manufacturer’s warranty
does not cover user abuse or improper installations.
• The power cord must be replaced when using dierent voltage than the
voltage specied. For more information, contact your dealer.
• When connected to a power outlet, power is always owing into your
Display. To totally disconnect power, unplug the power cord.
• The lightning ash with arrowhead symbol within an equilateral triangle
is intended to alert the user to the presence of un-isolated, dangerous
voltage within the inside of your Display that may be of sucient
magnitude to constitute a risk of electric shock to persons.
• Do not overload power strips and extension cords. Overloading can
To Next Page
Loading...
Need help?
General
Weight and Dimensions
