Equipment
Description
Equipment Description
- 10 -
Figure 1
3.1 Pumping Equipment,
Main Components
1.- Discharge Flange
2.- Water Cutting Rubber
3.- Monoblock Shaft Clamp
4.- Motor Lifting Eyebolt
5.- Electric Motor
6.- Motor Terminal Box
7.- Pumping Equipment Base
8.- Union Body
9.- Pump Body
10.- Suction Mouth
11.- Priming plug
12.- Drain plug
The operation of a centrifugal pump, chosen in accordance with all the technical background, can give poor service for
various reasons. This is generally due to improper installation or mishandling of the pumping equipment.
Efficient service can only be achieved by installing the pump correctly, therefore, the instructions in this manual must be
complied with in their entirety. Pumps should not be used for purposes other than the service conditions stipulated at
the time of purchase. The nameplate installed on the pump describes the most important features of the equipment
purchased:
5
3.2 Identification Plate
1.- Height (mca)
2.- Electric Motor
3.- Pump Series
4.- Pump Model
5.- Pump Material Wetted Zone Pump
6.- Pump Type of Execution
7.- Sealing Type
8.- Nominal Impeller Ø
9.- Motor Cover Standard
10.- Impeller Ø
11.- Flow Rate (m³/h)
12.- Pump Serial No.
Figure 2
To Next Page
Need help?
General
