2010 Volkswagen CC Quick Start Guide
19 |
Position power seats
Proper seat adjustment increase the level of protection offered by safety belts and airbags.
Figure 2.9
Adjusting seat angle forward or back:
1. Push the vertical button.
2. Toward the front to decrease the angle.
3. Toward the back to increase the angle.
Move the seat forward or back
1. Push the horizontal button.
2. Toward the front to move the seat forward.
3. Toward the rear to move the seat back-
ward.
Set the seat height
1. Use the same horizontal button.
2. Pull up to raise the seat.
3. Push down to lower the seat.
Adjust the lumbar support
1. Use the circular button.
2. The up/down controls move the lumbar
support up or down.
3. The front/rear controls inflate or deflate
the lumbar support.
(Note: This feature allows you to customize the
comfort of your lower back.)
Lights
Instrument panel switches for headlights, automatic headlights control and front fog lights.
Figure 2.10
Daytime running lights:
Daytime running lights come on whenever
the ignition is switched on, the headlight
switch is in position 0, and the parking
brake is released.
Taillights and instrument panel lights do not
come on unless, when darkness or other
condition require it.
Automatic headlights:
To turn on automatic headlights control,
turn the light switch to the AUTO position.
Headlight off:
Turn the light switch to 0 position.
Headlight on:
Turn the light switch to right position.
Fog lights on:
Pull the switch out from the Headlight position.
WARNING
Crash and other accidents can happen
when you can not see the road ahead
when you can not be seen by other mo-
tors.
Never use daytime running light to see
where you are going.