DO-IT-YOURSELF
V5-JL__
S3 A
RADIO
SET
•": :.'. r,g points should be noted
-
r-
-s:a ling a radio set:
• ft is advisable to use radio sets from
:_e
,.A.G
Accessory
programme as well
as
:ne
fitting
kits, aerials and suppres-
siori sets which have been specially
developed
for the individual vehicle
-nodel and are available from all V.A.G
workshops.
These parts are supplied
with
detailed
fitting
instructions.
The
use of other parts or parts from the
previous models may because faulty
operation of the system. Furthermore
the installation of non-approved
suppression
sets can affect the registra-
tion
of the vehicle under the Construc-
tion
and Use regulations in
cases
of
aoubt V.A.G workshops will advise.
• When installing the aerial it is
essen-
tial to ensure
that
the hole provided by
the factory where the aerial enters the
body is sealed very carefully. In addition
the aerial cable, the connecting wires
and
loudspeaker wires must be routed
so
that
they cannot chafe,
rattle
or get
tangled up
with
moving parts (e.g. pedals,
steering,
heating controls etc.). Other-
wise
the operation of the controls may
be
affected or vehicle safety impaired.
• The wiring is already installed at the
radio
fitting
location. The plug on this
wiring loom
fits
all radio sets in the
V.A.G
Accessory
Programme which have
a
separate connection for the
scale
lighting.
Radio
sets
with
other connections must
be
connected
with
an adapter wire which
can
also be obtained from V.A.G work-
shops.
If the adapter wire is not used or
if wires are cut off and
left
without
insu-
lation there is a risk of short circuiting.
This can cause the
wiring
to
burn
out.
110
To Next Page
Loading...
Need help?
General
