STARTING THE ENGINE
General
notes
• Be
careful
when
running
the
engine
in a confined space.
Danger
of poison-
ing.
• Check
that
gear lever is in neutral.
(On vehicles
with
automatic gearbox:
Selector
lever at "P" or "N") and apply
handbrake firmly before starting.
• Depress the clutch pedal on vehicles
with
manual gearbox when starting so
that
the starter only has to
turn
the en-
gine.
• As soon as the engine starts, release
the ignition key so
that
the starter can
disengage.
• After starting a cold engine it may
sound
noisy briefly because the oil pres-
sure
has to build up in the hydraulic tap-
pets^
first.
This is normal and no cause
for alarm.
• Do not warm engine up by running it
with
vehicle stationary. Drive off straight
away.
• Do not overrev or use
full
throttle
until the engine has reached the normal
operating temperature.
• On vehicles
with
a
catalytic
convert-
er the
engine
must
not be
started
when
catalytic
converter
is at
operating
tem-
perature
by
towing
the
vehicle
a long
distance as
otherwise
unburnt
petrol
can get
into
the
catalytic
converter
and
be
burned
there
- see also
page
83.
44 and 57 kW
carburetor
engines
Starting
a cold
engine
The
carburetor is
fitted
with
an automatic
choke
which is actuated the
first
time the
accelerator
pedal is depressed when
engine is cold.
• Depress accelerator pedal slowly
once
(twice
when
it is
freezing)
and then
release
it.
• Start engine - do not use accelera-
tor.
• If the engine does not start at once,
stop using starter after 10 seconds, wait
about half a minute and then try again.
• The increase in the idling speed which
takes
place as engine starts to warm up
can
be reduced by
just
tapping the
accel-
erator pedal briefly.
On vehicles
with
an
automatic
gearbox
the engine should be run at fast idling
speed
for about one minute after start-
ing when it is very cold.
The
pedal should then be tapped so
that
the speed drops and a gear can be
selected
at normal idling
speed.
Starting
a
warm
or hot
engine
• Depress pedal slowly
while
operat-
ing starter and hold it in the
full
throttle
position - do not pump the pedal!
•
Release
pedal as soon as engine
starts.
31