Volvo Penta D1 User Manual

Propeller Shaft Sealing, Check
If the boat is fitted with a Volvo Penta propeller shaft,
the propeller shaft seals must be lubricated before
launch and purged directly after launching.
Purge the glands by pressing them together, at the
same time as they are pressed down onto the shaft.
The press approximately 1 cm³ of water resistant
grease into the seal.
Maintenance
58 47702088 05-2011
47702088 - Downloaded from www.volvopenta.com 02/06/2011 18:54:55

Volvo Penta D1 Specifications

General

Engine Type	Diesel
Number of Cylinders	3
Fuel System	Direct injection
Rated RPM	3200 rpm
Cooling System	Freshwater with heat exchanger