4 Install one propeller blade to the hub and press in
the cotter pin (1) so that the groove in the pin is
aligned with the lock screw hole (2). Apply thread
locking fluid to the lock screw and tighten it to 10
Nm.
5 Install the blades the same way in consecutive
order. Check that the blades have the same angle
to the propeller shaft and that they move easily.
Maintenance
47702088 05-2011 63
47702088 - Downloaded from www.volvopenta.com 02/06/2011 18:54:55
To Next Page
Loading...
