Conservation of the lubrication and fuel systems for more than 8 months’ stoppage:
•
Drain the oil from the sump and engine and fill the
engine up with conservation oil* to just above the
MIN marking on the dipstick.
•
Connect the fuel supply (1) and return fuel pipes (2)
to a jerrican filled with 1/3 conservation oil*and 2/3
diesel fuel.
•
Vent the fuel system.
•
Start the engine and run at a fast idle until about 2
litres (0.5 US gals.) have been used.
Stop the engine and connect the ordinary fuel pipes.
•
Empty the conservation oil out of the engine.
•
Follow the other instructions on the previous page.
* Conservation oils are sold by oil companies.
Bringing Out of Storage
•
Remove any covers from the engine, air inlet and
exhaust pipe.
•
Top the engine up with the correct quality of oil if
necessary, see Technical Data, page 68. Install a
new oil filter if the filter was not changed during
conservation.
•
Check that there is oil in the reversing gear.
•
Install new fuel filters and vent the fuel system.
•
Check the drive belt(s).
•
Check the condition of all rubber hoses, and re-
tighten the hose clamps.
•
Close the drain taps and install the drain plugs.
•
Insert the impeller in the seawater pump, using a
rotating movement (anti-clockwise).
•
Check the coolant level and anti-freeze. Top up if
necessary.
•
Connect the fully charged batteries.
•
Open the sea cocks.
•
Start the engine (if the boat is in the water) and warm
up at a fast idle before loading the engine.
•
Check that no oil, fuel or coolant leakage occurs.
•
Check the oil level in the reversing gear. Top up if
necessary.
Storage
66 47713336 03-2021 © AB VOLVO PENTA
To Next Page
Loading...
Need help?
General
