22
Starting the engine
Starting procedure
1. Disengage the reverse gear
Put the control lever into neutral and idle on all control
positions
Dual lever control: Make sure that the accelerator is in
idle position (all the way back).
2. Switch on the power
Turn the start key to position “I” to switch on the power.
3. Check the warning lamps and alarm
Check that the lamps in the warning display and the
acoustic alarm are functioning by pressing the “Alarm
test” button on the instrument panel.
4. Activate the control position
Press the activation button for at least one second. The
indicator lights to confirm the control position is activat-
ed when the button is released.
NOTE! If the indicator flashes, the control position has
not been activated because the control lever(s) are not
in the neutral position.
5. Start the engine
Start using the ignition switch:
Turn the key to position “III”. Release the key and let it
key spring back to position “I” as soon as the engine
has started.
NOTE! If repeated start attempts are needed, the key
must be turned back to position “0” first (Note: The con-
trol position must be reactivated if the key is turned to
position “S”).
To Next Page
Loading...
Need help?
General
