REAR PANEL
1. 6.3mm Jack inputs.
Two 6.3mm jack female input connector for connecting a signal source (mixer etc.).
2. RCA inputs.
Two RCA input connector for connecting a signal source (mixer etc.).
3. Mode Switch.
The amplifier can use 2 different modes: stereo & bridge.
Choose one of these functions:
Stereo mode: Standard left/right stereo mode.
Bridge mode: This mode combines both amps on one channel which results in double power on this channel.
Connects the signal to the left input channel and the output level can now be adjusted with the left volume
control.
4. Ground Lift Switch.
Allows circuit and chassis grounds to be separated in case of problems with earth loops (hum)..
5. 6.3mm Jack Outputs.
Maximum load in stereo mode 4 Ohm per channel.
6. Speaker Outputs NL4.
Maximum load in stereo mode 4 Ohm per channel.
Pin +1 & +2 = + output, Pin -1 & -2 = - output
7. Binding Post Output Jacks.
Maximum load in stereo mode 4 Ohm per channel. Maximum load in bridge mode 8 Ohm.
8. Mains Power Connector
9. Fuse
This main fuse secures the amplifier and wires against defects. Replace this only with a fuse of same type
and value.
To Next Page
Loading...
Need help?
General
