3
Owner’s Manual
INTRODUCTION
Congratulations on your purchase of the VOX AC4C1/AC4C1-TV/AC4C1-12!
Based on the legendary VOX Top Boost circuit, this is the perfect balance between com-
pact size and killer sound. Designed to give you rocking tone without waking the neigh-
bours, the AC4C1/AC4C1-TV/AC4C1-12’s class A power stage can be cranked to sta-
dium tour saturation levels without leaving your sitting room or home studio! A luxury
which is hard to find in an all-tube amp.
Using the same tube compliment and circuit topology as the original “Top Boost” preamp
circuit design, the AC4C1/AC4C1-TV/AC4C1-12 will give you the unmistakeable VOX
tone that is loved and desired by VOX fans and tone-chasers the world over!
ENJOY!
VOX
FRONT PANEL LAYOUT
1. INPUT JACK Insert your guitar here!
2. GAIN This controls the preamp volume and will determine the amount of
preamp distortion. For a clean sound, the knob should be set some-
where before 12 o’clock and for more distortion… crank it!
(NOTE: Because of the nature of the design of this amplifier, it may
take a few minutes until the circuit becomes stable after the power is
turned on. Some noise might occur during this time but it soon disap-
pears.)
3. BASS This controls the low frequencies in your sound—from thin and light
when turned down (counter clockwise) to warm and fat when turned
up full (clockwise) and all points in-between.
4. TREBLE This controls the high frequencies in your sound—from soft and
smooth when turned down (counter clockwise) to bright and cutting
when cranked (clockwise) and all points in-between.
5. VOLUME This controls the overall volume of your amplifier and because this is
a single ended, class A design it will also have an effect on the amount
of distortion in the power amp.
To Next Page
Loading...
Need help?
General
