4
6. POWER SWITCH This turns the amp on and off!
7. INDICATOR This will tell you if your amp is on or off!
REAR PANEL LAYOUT
1. MAINS INPUT Connect your supplied mains power lead here.
NOTE: Use only the power cable that is included with the AC4C1/AC4C1-TV/
AC4C1-12. Using another power cable may cause malfunctions.
The specific mains input voltage rating that your amplifier needs to run
at is located on the rear panel of your amplifier. Before making any
connections or powering up the amplifier, make sure the correct volt-
age is set. If you have any doubt, refer to your local VOX dealer.
2. EXTERNAL SPEAKER OUT
This is used to connect the AC4C1/AC4C1-TV/AC4C1-12 to any
16ohm cabinet.
NOTE: When an external cabinet is connected, the internal speaker is dis-
connected.
WARNING: To ensure that your system works correctly, you must observe the
following points.
a) Don’t use an external cabinet whose impedance is other than 16
ohms.
b) Don’t connect a speaker whose rated input capacity is less than 4
Watts. The speaker may be destroyed if you ignore this caution—not
recommended!
c) You must use a speaker cable to connect an external speaker. Don’t
use a shielded cable like the one you use to connect a guitar to an
amp.
d) You must turn off the power before connecting the cable. Connecting
the cable while the power is turned on may damage your amp.
NOTE: It is recommended that all audio cables, with the exception of the
speaker lead, used to connect to the AC4C1/AC4C1-TV/AC4C1-12 of
a high quality, screened type. These should not exceed 10 metres in
length. Always use a non-screened speaker lead with the AC4C1/
AC4C1-TV/AC4C1-12 Amplifier and external cabinets.
1
2
To Next Page
Loading...
Need help?
General
