16
RESTORING THE FACTORY SETTINGS
Here’s how you can restore the factory settings.
NOTE: If you do this, the programs you saved in Channel 1 and 2 will be completely
erased, and will be reset to the factory settings.
NOTE: Effect and noise reduction settings made in the Manual mode will also be erased.
NOTE: Never turn off the power while initialization is taking place.
1. Turn the power off.
2. While holding down both the CH and WRITE buttons, turn the power on.
When the CH1 and CH2 LEDs begin blinking, release these two buttons.
HINT: If you decide to abort this operation, press the TAP switch at this point.
3. Now press the WRITE switch and the CH1 and CH2 LEDs will change from
blinking to lit. Initialization will be completed in a few seconds, and the amp
will switch to Preset mode.
To Next Page
Loading...
Need help?
General
