Page 5
AUXILIARY INPUT
1) Push Power Switch (10) “On”.
2) Using the source Selectors (4), choose the button labeled “AUX”.
3) If there is an external source (example: CD shuttle) connected to the Auxiliary Input Jacks (24)
on the rear of the radio, then you can listen to your external source through the system.
SETTING THE CLOCK
1) Push Power Switch (10) “On”.
2) Press the T/F button to display the clock
3) Hold the T/F button (16) and simultaneously use the H and M buttons
(19 and 20) to adjust hours and minutes.
Note: The T/F also toggles between time and radio frequency on the display.
USING THE AUDIO ADJUST BUTTON
1) You can toggle between volume, treble, bass and balance control by pressing the Audio Adjust
button (9)
2) Once at the desired function, you can use the volume buttons to adjust.
SETTING THE ALARM
1) Hold the Alarm set button (5)
2) Use the H and M buttons (19 and 20) to adjust hours and minutes.
3) The alarm On/Off button (6) activates or deactivates the alarm.
BEEP FEATURE
1) Hold the Audio Adjust button to enable the beep feature (9). Lower right side of the display will
display an audio symbol when this feature is turned on.
2) When this feature is on, turning different features on or off will produce two different tones,
higher tone for ON and lower tone for OFF.
3) Completely removing power from the unit will turn the beep feature off.
To Next Page
Loading...
General