7
SET UP THE BABY MONITOR
2.4 Baby unit installation options
The baby unit is ready for tabletop use. Use the provided wall mount if
you want to mount it on a wall. Make sure to test the reception and the
baby unit position before completing the wall mounting installation (see
Test your video and audio monitor before use on 23).
2.4.1 Tabletop to wall mount installation
Option 1: Use this method to x the wall mount securely on the wall.
Place the wall mount on a wall and then use a pencil to mark the top
two holes as shown. Then remove the wall mount and drill two holes
in the wall. Check for reception strength and camera angle before
drilling the holes.
If you drill the holes into a stud, go to step 3.
-OR-
If you drill the holes into an object other than a stud, insert the wall
anchors into the holes and tap gently on the ends with a hammer
until the wall anchors are ush with the wall.
1.
2.
To Next Page
Loading...
Need help?
General
