EN - 9
English
Installation option - converting from desktop to wall mount position
To mount the telephone base on the wall
1. Unmount the base stand. Put the cordless
handset aside. On the telephone base,
press the wall mount clip upward and
rotate a half turn (180°). Slide back the clip.
• It locks into place with the protruding
edge pointing towards the upper edge
of the telephone base. This protruding
edge holds the cordless handset when
the phone is mounted on the wall.
2. Install the telephone base as shown.
Note
• The adapter is sold separately.
3. Turn the telephone base over with the
bottom side facing up. Insert the mounting
bracket into the two upper grooves and
a lower groove on the telephone base
until they lock securely. In the meantime,
the telephone cord sticks out from the
rectangular hole and affix coil handset
cord by fitting it in the semi-circle holes
at the bottom of the mounting bracket as
shown below.
4. Mount the telephone base on the wall by
positioning the eyelets on the telephone
base and the mounting bracket against the
mounting studs. Then slide the telephone
base down on both mounting studs until it
locks into place.
5. Replace the handset on the telephone
base cradle.
To Next Page
Loading...
Need help?
General
