4
Battery installation
After you install the handset battery, the handset will prompt you to set the
date and time. The handset will also prompt you to set the date and time
after a power failure. For instructions, see Set date and time on page 9. To
skip, press OFF/CANCEL.
Install the battery as shown below.
Plug the battery connector securely into the socket inside the handset
battery compartment.
Place the battery with the label THIS SIDE UP facing up and the wires
inside the battery compartment.
Align the cover at against the battery compartment, then slide it
towards the center of the handset until it clicks into place.
Charge the handset by placing it in the telephone base. The
CHARGE light remains on whenever the handset is charging in the
telephone base.
1.
2.
3.
4.
If the handset will not be used for a long period of time, disconnect and
remove the battery to prevent any possible leakage.
To purchase a replacement battery, visit our website at
www.vtechphones.com or call 1 (800) 595-9511. In Canada, go to
www.vtechcanada.com or call 1 (800) 267-7377.
•
•
3
To Next Page
Loading...
Need help?
General
