Appendix
77
Deregister handsets/headset
If you want to replace a handset or headset, or reassign the designated handset
number of a registered handset, you must deregister all handsets and headsets
that are registered to the telephone base. Then register each handset and headset
individually.
To make deregistration easier, read all of the instructions on this page before
you begin.
Make sure that all handsets are out of the telephone base and handset chargers
before you begin deregistration.
To deregister all handsets and headsets:
Press and hold FIND HANDSET on the telephone base for about 10 seconds
until the IN USE light on the telephone base turns on and starts flashing.
Immediately press FIND HANDSET again. You must press FIND HANDSET
while the IN USE light is still flashing. The IN USE light flashes for approximately
five seconds.
All handsets show To register HS, see manual. and all headset lights
flash slowly and alternately in red and blue when the deregistration process
completes. The deregistration process takes about 10 seconds to complete.
If the deregistration process is successful, you hear “Not registered” through the
headset earpiece when you press on the headset. If deregistration fails, you may
need to reset the telephone and try again.
To reset:
Pick up the registered handset. Press /HOME and then press OFF/CANCEL.
Place the handset in the telephone base.
Pick up the registered headset and press the RESET recessed key with a paper
clip or similar object.
-OR-
Unplug the power from the telephone base, then plug it back in.
You cannot deregister all handsets and headsets if any other system handset or
headset is in use.
1.
2.
3.
1.
2.
Appendix
To Next Page
Loading...
Need help?
General
