VTech Go! Go! Cory Carson DJ Train Trax & the Roll Train User Manual

4
Unlock the Packaging Locks
GETTING STARTED
Battery Removal and Installation
DJ Train Trax
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom
of DJ Train Trax, use a screwdriver to
loosen the screw and open the battery
cover.
3. Remove old batteries by pulling up on one
end of each battery.
4. Install 2 new AAA (AM-4/LR03) batteries
following the diagram inside the
battery box. (The use of new alkaline
batteries is recommended for maximum
performance.)
5. Replace the battery cover and tighten the screw to secure.
Turn the packaging lock counterclockwise
several times.
Pull out the packaging lock and discard.
Rotate the packaging lock 90 degrees
counterclockwise.
Pull out the packaging lock and discard.

VTech Go! Go! Cory Carson DJ Train Trax & the Roll Train Specifications

General

Brand	VTech
Model	Go! Go! Cory Carson DJ Train Trax & the Roll Train
Category	Toy
Language	English