WARNING
• Please keep your KidiMagic StarLight away from strong light or
direct sunlight, it will interfere with the magic sensor.
• To avoid poor operation, please ensure there are no obstacles such
as a shelf close to the top of the unit.
• If the sensor detects an obstacle that impedes the performance of
the unit, you will see a warning icon on the screen.
SPECIAL WARNING ICON
Low Battery
This icon will appear when the battery
power is low. Please replace the
batteries.
Bad Signal
The animation will appear when an
object is within the sensor range for an
extended period of time and reduces the
performance.
INSTRUCTIONS
BATTERY REMOVAL AND INSTALLATION
KidiMagic StarLight uses 4 AA batteries or a VTech
®
6V adaptor
(sold separately).
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back of the unit. Use a screwdriver
to loosen the screw and then open the battery cover.
3. If used batteries are present, remove these batteries from the unit
by pulling up on one end of each battery.
4. Install 4 new AA (AM-3/LR6) batteries following the diagram inside
the battery box. (For best performance, alkaline batteries or fully
charged Ni-MH rechargeable batteries are recommended).
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
520403 IM REV.indd 7520403 IM REV.indd 7 2021/8/6 9:29:332021/8/6 9:29:33
To Next Page
Loading...
Need help?
General