VTech Move & Crawl Ball User Manual

13
or move the highlight to to cancel adding an opening and return to
the video editing menu.
2. Cut Video
Press the Up or Down cursor button to select
a function in the cut video menu.
A. Set the start point
B. Set end point
C. Done
D. Return
When the highlight is on or , press the Left or Right cursor
button to move the start / end pointer on the timeline to set a new start
position or end position of the video. After moving the pointer to the
position you want, press the Up or Down cursor button to select
and press the OK button to conrm cutting the video from the
start pointer to the end pointer. Or select the to cancel the cutting
and return to the video editing menu.
3. Play Video
See your edited video here.
• Press the Left
or Right cursor key once to use the fast rewind or
forward in 2X, press this button again to change to 4X and press it one
more time to return to 1X playing speed.
• Press the OK button
to stop playing the video and return to the
editing menu.
4. Save As
Save your edited video as a new video.
NOTE: It may take a long time for the saving process to nish. E.g. a
10 minute video may take 10 minutes to save. Make sure the battery
status is good. Do not remove the SD card (if inserted) while in the saving
process. If the free memory is low, the editing le may not be saved.
Make sure there is enough free memory before starting editing.
F. SETTINGS
You can change the setting of language, self-timer,
video resolution, indoor light frequency, memory
and date & time setting here. After entering a
specic setting menu, select
to return without
saving any changes.
1. Language
Press the Up
or Down cursor button to select a language and
press the OK button to conrm your selection.
2. Self-timer
Press the Up
or Down cursor button to set the self-timer on or off
Activities

VTech Move & Crawl Ball Specifications

General

Brand	VTech
Model	Move & Crawl Ball
Category	Toy
Language	English