To Begin Using Movie Magic DigiCam
SD CARD INSERTION
• Make sure Movie Magic DigiCam™ is turned OFF.
•
Locate the SD card slot at the top of the video camera.
• Pull up the rubber cover.
• Insert the SD/SDHC card (not included) as
illustrated. Once SD/SDHC card is detected
and can be used, the default memory will
set as SD/SDHC card memory automatically.
• To remove the SD/SDHC card from the slot, push
the card once and it will eject.
TO BEGIN USING MOVIE MAGIC DIGICAM
• Press the ON/OFF button to turn on the video camera.
• If it is the rst time that you are turning on the video camera, the Try-
me demo movie will start playing. Press the OK Button
to exit the
Try-me demo mode. The Try-me demo will be disabled and will not
play again on start-up.
• After the video camera exits demo mode, the language selection
screen will appear. Press the Up
or Down Cursor Button to select
a language, and then press the OK Button to conrm. You have
to set the date and time after selecting the language. Press the Up
or Down Cursor Button to select the correct day, month, year, hour
and minutes. Press the Left or Right Cursor Button to jump to the
previous or the next setting item. Finally press OK button to conrm
the setting. If you wish to change the language or date & time later,
please go to Settings.
• After the Try-me demo mode has been disabled, when turning on, it
will go directly into the preview screen of the selected mode, and you
can start recording movies or taking photos.
• To change to different modes, switch the Mode Slide Switch
to
the upper position to change to Video Mode , switch to the middle
position to change to Director Mode or switch to the bottom position
to change to Camera Mode .
• Press the home button
to go to the home menu for other activities:
record , playback , games , video editor , volume setting
or settings .
• Refer to the “Activities” section below for detailed descriptions of each
mode.
• Press the ON/OFF button
again to turn the unit off.
To Next Page
Loading...
Need help?
General