6
NOTE: The actual capacity depends on the shooting environment.
GETTING STARTED
BATTERY INSTALLATION
Note: Adult assembly is required for
battery installation. Tools required for
battery installation: Slotted (at head)
screwdriver / coin (not included).
• Make sure the video camera is turned OFF.
• Locate the battery cover on the bottom of the video camera. Loosen
the screw using a screwdriver and remove the battery cover.
• Install 4 “AA” batteries as illustrated above. (The use of new, alkaline
batteries is recommended for maximum performance. Ni-MH
rechargeable batteries are also supported.)
• Replace the battery cover and tighten the screw. Do not over-tighten
the screw.
Note: If Movie Magic DigiCam™ is not working properly after the
batteries have been replaced, press the Reset Button and then restart
the video camera.
BATTERY NOTICE
• The use of new alkaline batteries is recommended for maximum
performance.
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the toy before being
charged (if removable).
• Rechargeable batteries are only to be charged under adult supervision
(if removable).
• Do not mix old and new batteries.
• Do not mix batteries of different types: alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium)
• Only batteries of the same or equivalent type as recommended are to
be used;
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the toy.
• The supply terminals are not to be short-circuited.
• The toy is not to be connected to more than the recommended number
of power supplies.
• Do not dispose of batteries in re.
Getting Started
To Next Page
Need help?
General