There is no picture
on the TV screen
when connecting
Movie Magic
DigiCam™ to TV
1. Make sure that there are batteries in the video
camera and that the TV is plugged into a
power outlet.
2. Make sure the video camera is turned on and
the TV is turned on.
3. Check the connections on the A/V cable
between the video camera and the TV, and
review the appropriate connection procedure
in this manual.
4. Make sure that all cable plugs are securely
inserted into the appropriate ports.
5. Make sure that the TV is tuned to the
appropriate input channel.
No sound on TV 1. Check if the TV volume is turned off or muted.
2. Try to increase the volume.
3. Check the audio and video connections
between the camera and the TV.
4. Make sure that the TV is tuned to the
appropriate input channel.
Picture is rolling
or bars and lines
are visible on TV
screen
Try to adjust the vertical or horizontal hold
controls (if available) on your TV.
Cannot connect to
computer
Check the connections on the USB cable
between the video camera and the computer,
and review the appropriate connection procedure
in this manual.
SD Card can’t be
detected
1. Check if the SD card is correctly inserted.
2. Check if the SD card is less than 32MB in
capacity. The video camera doesn’t support
SD cards less than 32MB.
3. Check to see if the SD card is the supported
type. The Movie Magic DigiCam™ doesn’t
support MMC or other formats.
Cannot save les Check the memory status of the SD card memory
to see if it is full, and check if the SD card is write-
protected. If there is no SD card inserted, check
the Movie Magic DigiCam™ internal memory
Troubleshooting
To Next Page
Loading...
Need help?
General