VTech SN5107 User Manual

The battery is low and needs charging.
The battery is charging.
The battery is fully charged.
The handset speakerphone is in use.
The handset ringer is off.
New voicemail received from your telephone service provider.
MUTE The handset microphone is muted.
NEW There are new caller ID log entries.
ANS ON Answering system is on.
There are new messages in the answering system.
The number of new/old messages recorded.
The handset Audio Assist® feature is on.
Audio Assist® is a registered trademark of Advanced American Telephones.
Install the battery
Install the battery as shown below.
Cautions
Use only the rechargeable batteries provided or replacement batteries (model BT205662).
Do not use other alkaline, manganese, or Ni-Cd batteries, nor other non-rechargeable batteries for operating the cordless handset. They may cause failure or malfunction of the
handset or the telephone system.
Notes
Charge the batteries provided with this product only in accordance with the instructions and limitations specified in this manual.
If the handset will not be used for a long time, disconnect and remove the batteries to prevent possible leakage.
Connect and charge the battery
Notes
• Use only the adapter provided.
Connect the charger

VTech SN5107 Specifications

Frequency Specifications

frequency control	Crystal controlled PLL synthesizer
transmit frequency	1921.536-1928.448 MHz
channels	5

Power

handset power requirements	1.2V 500mAh, 3 x AAA Ni-MH battery
charger power requirements	6V DC @ 400mA

Memory

handset phonebook memory locations	50 memory locations; up to 30 digits and 15 characters
handset caller ID memory log	50 memory locations; up to 24 digits and 15 characters
handset call block entries	1000 entries