68
69
NOTES
• The pairing process may take up to
one minute. If the pairing process
fails, try again.
• When a connected headset is
charging, it may disconnect from
the telephone base and the
CELL 2/HEADSET light on the
telephone base turns off. For some
headset models, you may need to
turn on the headset and reconnect it
to the telephone base again.
Auto connection
When an active device moves within
Bluetooth range of the telephone base,
or is turned on within range, the
telephone base tries to connect to the
device. When the device moves out of
range, it is disconnected. Your device
might make a connect or disconnect
sound.
A connected device could also be
disconnected by:
• Turning off the Bluetooth device.
• Turning off the Bluetooth feature of
the device.
• Disconnecting through the telephone
base Device list. If you disconnect
through the Device list, the telephone
base will not attempt to reconnect
until your device is moved out of
range and then moves back in range
again.
Device list and connection
Up to 2 devices can be paired to the
telephone base. All paired devices are
shown on the device list. To use a paired
device, it must be connected. Both
Bluetooth enabled devices can be used
on a cell call at a time.
Once you have paired a device with the
telephone base, you do not need to
repeat the pairing procedure again
unless you delete the device from the
device list.
NOTE
• When connecting a Bluetooth device
to the device list, all connected devices
will be temporarily disconnected until
the procedure is complete. It may take
up to two minutes to reconnect.
Review the device list
1. Press MENU/SELECT on the telephone
base in idle mode to enter the main
menu.
2. Press q CID or p to
highlight Bluetooth, then press
MENU/SELECT.
3. Press MENU/SELECT again to select
Device list.
Connect/disconnect an active device
While in the device list menu, you
may connect or disconnect your active
device.
1. Press MENU/SELECT on the
telephone base in idle mode to enter
the main menu.
2. Press q CID or p to
highlight Bluetooth, then press
MENU/SELECT.
3. Press q CID or p to
highlight Device list, then press
MENU/SELECT.
4. Press q CID or p to highlight a
device, then press MENU/SELECT.
5. Press q CID or p to highlight
Connect/Disconnect (whichever
is applicable), then press
MENU/SELECT. The telephone
base displays Device connected/
Device disconnected. You hear a
confirmation tone.
NOTE
• When your active device is
connected, you are prompted to
select Disconnect. When your active
device is disconnected, you are
prompted to select Connect.
Remove a paired device
When you already have 2 devices on the
device list and you want to add another
device, you must first delete one from
the list. You can only pair 2 cell phones
or one cell phone and one Bluetooth
headset.
To remove a paired device:
1. Press MENU/SELECT on the
telephone base in idle mode to enter
the main menu.
2. Press q CID or p to
highlight Bluetooth, then press
MENU/SELECT.
3. Press q CID or p to
highlight Device list, then press
MENU/SELECT.
4. Press q CID or p to highlight
the desired device, then press
X/DELETE.
-OR-
• Press q CID or p to highlight
the desired device, then press
MENU/SELECT.
• Press q CID or p to
highlight Remove, then press
MENU/SELECT.
5. The telephone base displays Remove
Headset X? (Headset X represents
the device name of your Bluetooth
headset). Press MENU/SELECT to
confirm. The telephone base displays
Device removed from device list
and you hear a confirmation tone.
To Next Page
Loading...
Need help?
General
