Maintenance BS 50-4
wc_tx000309gb.fm 34
6.7 Transportation
See Graphic: wc_gr001457
6.7.1 Always shut off engine and close fuel valve when transporting
machine.
6.7.2 Make sure lifting device has enough capacity to hold machine (see
identification plate on machine for weight).
6.7.3 Use central lifting point (a) when lifting machine.
Always inspect crane lifting cable for wear, damage, or abuse. Protect
cable from any sharp edges. Do not use if there are any signs of cut
wires, excessive wear, or other defects. Replace damaged cable
immediately to avoid injury or death.
6.7.4 Wacker recommends transporting rammers upright whenever
possible; however, a rammer should not be allowed to fall over.
If the rammer cannot be secured in the upright position, tie down the
rammer to the transport vehicle to prevent it from tipping, falling, or
rolling. Lay the rammer down only as shown below and tie it to the
vehicle at points (a) and (b).
CAUTION: Drain the fuel tank as required to prevent fuel leaking from
the cap (c).
NOTE: After transporting the rammer horizontally, upright the rammer
and allow the oil to drain back through the engine. It may take up to 2
minutes for the oil level to recover.
WARNING
To Next Page
Loading...
Need help?
General
