Wacker Neuson BS 60-2 User Manual

BS 60-2 / BS 70-2 Lifting and Transporting
wc_tx001479gb.fm 21
3 Lifting and Transporting
3.1 Lifting and Transporting
See Graphic: wc_gr007405
3.1.1 Always shut off the engine and close the fuel valve when transporting
the machine.
3.1.2 Make sure the lifting device has enough capacity to hold the machine
(see identification plate on the machine for weight).
3.1.3 Use the central lifting point (a) when lifting the machine.
Always inspect the lifting cable (a) for wear, damage, or abuse. Protect
the cable from any sharp edges. Do not use the cable if there are any
signs of cut wires, excessive wear, or other defects. Replace the
damaged cable immediately to avoid injury or death.
3.1.4 Tie down the machine on the vehicle to prevent it from tipping, falling,
or rolling. Lay the machine down flat and tie it to the vehicle at points
(a) and (b).
NOTICE: Drain the fuel tank as required to prevent fuel leaking from
cap (c).
WARNING

Wacker Neuson BS 60-2 Specifications

General

Brand	Wacker Neuson
Model	BS 60-2
Category	Vibratory rammers & tampers
Language	English