10 Maintenance
100_0201_mt_0004.fm 27
10.2.2 Top off the fuel
1. Remove dirt accumulation in the area of the fuel cap.
2. Slowly unscrew the fuel cap and remove.
3. Top off the fuel with a clean funnel.
For the fuel specification, see the chapter Technical data.
For the fuel mixing specification, see the chapter Technical data.
4. Tighten the fuel cap.
10.2.3 Screwed connections
For vibratory rammers, all screwed connections must be checked to ensure a firm seat at regular
intervals. Loose screw connections must be tightened with the specified or standard torque setting.
10.2.4 Clean/replace the air cleaner
WARNING
Risk of fire and explosion from fuel and fuel vapors.
Do not smoke.
Do not refuel near open flames.
Switch off engine and allow it to cool before refueling.
CAUTION
Health risk from fuel.
Refuel in a well-ventilated area.
Do not inhale fuel vapors.
Avoid fuel contact with skin or eyes.
Item Designation
1Fuel cap
NOTICE
Slowly unscrew the fuel cap so that any existing excess pressure can slowly escape.
WARNING
Risk of explosion and fire
Do not use fuels or other solvents with a low flash point to clean the air filter.
Use compressed air, a mild cleaning agent or warm water.
NOTICE
Do not operate the machine without an air filter. This may lead to serious engine damage.